Anyone have a BX63A manual?

[doucanoe]

I just picked up a B380 with the BX63A active. The 2235H is now in the process of getting a refoam and it should be back in about two weeks.

One thing I don't have is an operation manual for the BX63A. I have looked the site over and don't think that there is one in the library unless I have missed something.

I found the tech manual but not the operation manual.

If anyone has one and could scan it for me, I would be very grateful. I would be glad to pay a little somthun, somethun for the effort

Thanks, RC

[Robh3606]

I have one. If you want I can scan it and post it here and if you send me your email I can send you the hi-res scans.

Rob

[Robh3606]

Rob

[doucanoe]

Hey Rob, thanks so much!

That works just fine for me and I won't make you go to the trouble of sending by email.

I'm excited about finding the B380 not to mention the BX63A that came along with it. I really wanted to be able to read what JBL had to say about the unit (operation manual) so now I'm set!

Now, all I have to do is find another at some point to round things off. My only problem now is that I am running out of listening room, well, room.

Thanks again, RC

[doucanoe]

Ok then, I have gone over the manual and I think that I am still missing (understanding) something.

I was planning on finding or purchasing another amp to drive the B380. It seems that I can use a stereo amp and the BX63a will address the summing duties for me. Thats great for the fact that I will not need to purchase a dedicated amp immediatly.

I am confused by one thing however. If I choose a LF output (normal or inverted) to the stereo amp for the sub, Which input on the amp do I connect to (left or right) or does it make a difference. Also, how by doing this, is this bridging the amp? The amp does not care as long as it receives a signal, correct, but that doesn't make it bridged. Am I missing something?

Life was much less complicated just using a stereo tube preamp and amp. Heck, I dont even use a remote in my main system

RC

[hjames]

Ok then, I have gone over the manual and I think that I am still missing (understanding) something.

I was planning on finding or purchasing another amp to drive the B380. It seems that I can use a stereo amp and the BX63a will address the summing duties for me. Thats great for the fact that I will not need to purchase a dedicated amp immediatly.

I am confused by one thing however. If I choose a LF output (normal or inverted) to the stereo amp for the sub, Which input on the amp do I connect to (left or right) or does it make a difference. Also, how by doing this, is this bridging the amp? The amp does not care as long as it receives a signal, correct, but that doesn't make it bridged. Am I missing something?

Life was much less complicated just using a stereo tube preamp and amp. Heck, I dont even use a remote in my main system

RC

From the reading of the manual it sounds like you are on your own for bridging an amp - they are recommending amp power in single channel mode. I know I am feeding my B380 with a Citation 22 - est 600w/mono (peaks) - but its an easily bridgable amp.