Well, shortly after my L200Bs followed me home, I picked up my L250s, so all of a sudden I ran out of any urgency to get the L200Bs going again. I'm finally doing it - basically just cleaning everything and refoaming the 136As - and have two questions.
1 - What's the best way to clean the surface of my 136A cones? They are extremely dusty and I'm afraid of using the wrong method and damaging or discoloring the cones.
2 - One of my ports has a little bit of damage to the cardboard. Is there a best practice for fixing this?
And here's a shot of them just because.
Thanks in advance,
Ryan